① Pass one cable through the end cover,the long tube,and central tuber in turn;pass the other cable through the end cover,long tube in turn.

② Strip off 30mm of cable jacket and fold braid back over it.Cut off aluminum foil for each pair,and use a supplied copper foil shield surrounding a cable.

③ Fan out four twisted pairs,following the colorcoding label and allocate each conductor intoproper slots on wiring cap.Trin the ends ofconductors.
 

④ Place wiring cap on connection module.Close connection module cover,make sure the drain wire is in proper contact with grounding clip on connection module.

⑤ Fasten supplied cable tie to secure grounding contact.

⑥ Install the cables to the modular according to the moduler instruction manual

⑦ Asemble two long tubes by rotating the threads.

Lock the two waterproof plugs on the cable,then put them into the end of the long tube.Note:The plug is engraved with the word "waterproof'on one side outward.

⑨Screw the end cover at both ends onto the long tube.Finally to check whether the waterproof plug is closely matched with the cables.